一般注記A method is described for the sequential determination of Sb(III) and Sb(V) using Osteryoung square wave cathodic stripping voltammetry. It employs an in-situ plated bismuth-film on edge-plane graphite substrate as the working electrode. Selective electro-deposition of Sb(III)/Sb(V) is accomplished by applying a potential of –500 mV vs Ag/AgCl, this followed by reduction to stibine at a more negative potential in the stripping step. Stripping was carried out by applying a square wave waveform between –500 and –1400 mV to the antimony deposited. The stripping peak current at –1150 mV is proportional to the concentration of Sb(III)/Sb(V). The calibration plots for Sb(III) were linear up to 12.0 μg L-1 depending on the time of deposition. The calibration plots for Sb(V) were linear up to 7.0 μg L-1,also depending on the time of deposition. The relative standard deviation in the determination of 0.1 μg L-1 of Sb(III) is 4.0% (n = 5), and the limit of detection is as low as 2 ng L-1. In case of 0.1 μg L-1 Sb(V), the relative standard deviation is 3.0% (n = 5) and the detection limit also is 2 ng L-1. The method was applied to the analysis of river water and of sea water samples.
一次資料へのリンクURLhttps://u-fukui.repo.nii.ac.jp/?action=repository_action_common_download&item_id=22570&item_no=1&attribute_id=22&file_no=1
連携機関・データベース国立情報学研究所 : 学術機関リポジトリデータベース(IRDB)(機関リポジトリ)