Formation of Porous Clay Ceramic Using Sago Waste Ash as a Prospective Additive Material with Controllable Milling

• 資料種別: 文書・図像類
• タイトル: Formation of Porous Clay Ceramic Using Sago Waste Ash as a Prospective Additive Material with Controllable Milling
• 著者・編者: Aripin, H.; Mitsudo, S.; Rahmat, B.; Tani, S.; Sako, K.; Fujii, Y.; Kikuchi, K.; Saito, T.; Idehara, T.; Sabchevski, S.
• 著者標目: Aripin, H.; Mitsudo, S.; Rahmat, B.; Tani, S.; Sako, K.; Fujii, Y.; Kikuchi, K.; Saito, T.; Idehara, T.; Sabchevski, S.
• 出版事項: International Institute for the Science of Sintering
• 出版年月日等: 2014-04
• 出版年（W3CDTF）: 2014-04
• タイトル（掲載誌）: Science of Sintering
• 巻号年月日等（掲載誌）: 46
• 掲載巻: 46
• 掲載ページ: 55-64
• ISSN（掲載誌）: ISSN : 0350-820X
• 本文の言語コード: eng
• 件名標目: Unglazed ceramic tile; Sago waste; Clay; Sintering temperature; Milling time; Water absorption; Hardness
• 対象利用者: 一般
• 一般注記: A novel type of ceramic material was produced by mixing sago waste ash from the sago processing industry in Indonesia with clay. The composition was prepared by adding 50 %wt amount of sago waste into the clay, then a series of samples was milled for 6 h, 12 h, 24 h and 48 h, respectively. The samples were dry pressed and sintered at temperatures ranging from 800 o C to 1200 o C. The influence of the sintering temperature and the milling time on bulk density, firing shrinkage, water adsorption, and hardness was studied in detail. The results demonstrate that the low water absorption of less than 0.5% and the highest hardness of 5.82 GPa were obtained for the sample sintered at 1100 o C and milled for 48 h. The investigation of the absorptive properties of such ceramics indicates that they could be recommended as a promising material for manufacturing of unglazed floor tiles.
• オンライン閲覧公開範囲: 限定公開
• 関連情報（DOI）: 10.2298/SOS1401055A
• 連携機関・データベース: 国立情報学研究所 : 学術機関リポジトリデータベース（IRDB）（機関リポジトリ）; https://irdb.nii.ac.jp
• 提供元機関・データベース: 福井大学 : 福井大学学術機関リポジトリ