本資料は、掲載誌(URI)等のリンク先にある学位授与機関のWebサイトやCiNii Dissertationsから、本文を自由に閲覧できる場合があります。
博士論文
国立国会図書館館内限定公開
収録元データベースで確認する
国立国会図書館デジタルコレクション
デジタルデータあり
Dynamics of melt-electrospinning and its application to the micro-fiber formation of biopolymers
- 国立国会図書館永続的識別子
- info:ndljp/pid/11720216
国立国会図書館での利用に関する注記
資料に関する注記
一般注記:
- type:ThesisThe thesis consists of three chapters on the dynamics of melt-electrospinning and its application to the micro-fiber formation of biopolyme...
書店で探す
障害者向け資料で読む
書店で探す
障害者向け資料で読む
書誌情報
この資料の詳細や典拠(同じ主題の資料を指すキーワード、著者名)等を確認できます。
デジタル
- 資料種別
- 博士論文
- タイトル
- 著者・編者
- XU, HUAIZHONG
- 著者標目
- 出版年月日等
- 2018-09-25
- 出版年(W3CDTF)
- 2018-09-25
- 並列タイトル等
- 溶融電界紡糸の動力学的解析とバイオマイクロファイバーの形成
- 授与機関名
- 京都工芸繊維大学
- 授与年月日
- 2018-09-25
- 授与年月日(W3CDTF)
- 2018-09-25
- 報告番号
- 甲第905号
- 学位
- 博士(工学)
- 博論授与番号
- 甲第905号
- 本文の言語コード
- eng
- 件名標目
- 対象利用者
- 一般
- 一般注記
- type:ThesisThe thesis consists of three chapters on the dynamics of melt-electrospinning and its application to the micro-fiber formation of biopolymers. The first chapter investigated the fabrication of core-sheath microfibers and the relationships among processing parameters, crystalline structures and the mechanical properties. The tensile strength and the modulus of the as-spun and the drawn fibers increased with increasing the take-up velocities. When the take-up velocity was above 500 m/min, jet became unstable and started to break up at the tip of Taylor-cone, decreasing the mechanical properties of the fibers. The drawing process facilitated the crystallization of PLLA and PHBH, and the tensile strength and the modulus increased linearly with increasing the draw ratio. The crystal information displayed from WAXD patterns and DSC heating curves supported the results of the tensile tests.The second chapter discussed the fabrication of ultrafine cellulose fibers with pure ionic liquid in high concentration. The maximum solubility of cellulose in 1-butyl-3-methylimidazolium chloride (BmimCl) can reach up to 20 wt% when the solution was stirred at 110 oC for 2 hours. The cellulose-BmimCl solution was then processed into homogeneous gels through the methods of recrystallization and casting. Pure cellulose fibers with perfect morphologies were achieved after melt-electrospinning and coagulation. The results of WAXD and FTIR indicated that the cellulose fibers were amorphous and chemically stable.The third chapter studied the electrodynamics and spinnability of melt electrospinning. A temperature-voltage phase diagram was constructed to distinguish the regimes of the bending, the whipping, and the break-up of the jet. Jet breaks up periodically at the tip of Taylor-cone if the polymer viscosity is too low or the elongation rate is not high enough to stretch the jet. The elongation rate for each segment of the jet keeps almost constant at a certain melt temperature, while the elongation rate increases and the solidification point of the jet shifts from the Taylor-cone to the target with increasing melt temperature. An analytic equation is proposed to estimate the jet diameter along the spinline before jet solidifies.
- 国立国会図書館永続的識別子
- info:ndljp/pid/11720216
- コレクション(共通)
- コレクション(障害者向け資料:レベル1)
- コレクション(個別)
- 国立国会図書館デジタルコレクション > デジタル化資料 > 博士論文
- 収集根拠
- 博士論文(自動収集)
- 受理日(W3CDTF)
- 2021-09-06T03:11:00+09:00
- 記録形式(IMT)
- application/pdf
- オンライン閲覧公開範囲
- 国立国会図書館内限定公開
- デジタル化資料送信
- 図書館・個人送信対象外
- 遠隔複写可否(NDL)
- 可
- 掲載誌(URI)
- 連携機関・データベース
- 国立国会図書館 : 国立国会図書館デジタルコレクション