Search by Bookstore
Holdings of Libraries in Japan
This page shows libraries in Japan other than the National Diet Library that hold the material.
Please contact your local library for information on how to use materials or whether it is possible to request materials from the holding libraries.
other
JOPSS:JAEA Originated Papers Searching System
DigitalYou can check the holdings of institutions and databases with which Institutional Repositories DataBase(IRDB)(Institutional Repository) is linked at the site of Institutional Repositories DataBase(IRDB)(Institutional Repository).
Search by Bookstore
Bibliographic Record
You can check the details of this material, its authority (keywords that refer to materials on the same subject, author's name, etc.), etc.
- Material Type
- 規格・テクニカルリポート類
- Author/Editor
- 根本 隆弘金城 紀幸関田 健司古澤 孝之黒羽 操川上 悟近藤 雅明
- Publication Date
- 2015-03
- Publication Date (W3CDTF)
- 2015
- Alternative Title
- Improvement in oil seal performance of gas compressor in HTTR, 2
- Periodical title
- JAEA-Technology 2015-006
- Target Audience
- 一般
- Note (General)
- 出版タイプ: NA高温工学試験研究炉(HTTR)の原子炉補助施設に設置しているガス圧縮機は、冷却材ヘリウムの漏えい防止等の観点から複雑なロッドシール機構を有している。一方、これまでの運転経験において当該シール機構からのシールオイル漏れが頻発していたため、シール材の変更等による洩れ対策を行ってきたが、期待した効果が得られなかった。そこで、シールオイル漏れが頻発しているガス圧縮機のシール材を、仕様の異なるものに交換したところ、シールオイル漏れの発生が大幅に低減した。検討の結果、個々のガス圧縮機の特性に応じた適切なシール材を選定することが、シールオイル漏れ対策に有効であることが確認できた。また、これまでの運用経験を踏まえて、HTTRのガス圧縮機により適切なシールオイル漏れに関する判断基準と運用方法を立案した。本報は、HTTRで使用しているガス圧縮機のシールオイル漏れに係る改善方法について検討した結果をまとめたものである。The High-Temperature engineering Test Reactor (HTTR) has been developed for establishing and upgrading the technical basis of HTGR.HTTR facilities have their structures, systems and a lot of components including reciprocating gas compressors, commonly used to extract and/or discharge reactor coolant helium gas contained in primary/secondary coolant systems. From the fact of the operational experiences of these compressors, seal-oil leakage has been frequently observed, although rod-seal mechanisms with complicated structures are equipped and improved for preventing coolant helium gas. So, we tried to change the rod-seal materials which might be a primary reason of frequent seal-oil leakage, that resulted in decreasing a mass and frequently of seal-oil leakage. It is confirmed that it is important to select adequate materials of rod seal for sliding speed of the piston of the compressor to prevent seal-oil leakage. Additionally, the procedure to estimate seal-oil leakage for each compressor is discussed. This report describes the results of investigation for improvement on seal-oil leak tightness of the compressors in HTTR facilities.
- Source
- /JAEA-Technology-2015-006.pdf (fulltext)